Arduino Nano 读取ADS1100实例

利用Arduino Nano的wire库可以很方便对ADS1100进行设置和读取转换后的数据。

/*
* Arduino reads ADS1100 I2C 16bit diff ADC
*/ /*
SDA ==> analog 4 PC4
SCL ==> analog 5 PC5 set register: STBY 0 0 SC DR1 DR0 PGA1 PGA0
default 1 0 0 0 1 1 0 0 0x8C
i want 1 0 0 0 1 1 0 0
ign 0 0 con 8SPS GAIN 1
STBY, only for single mode to start conversion
SC 1= single , 0=continuous
DR1:0 datarate 00 = 128sps, 12 bit -2048 to 2047
01 = 32sps, 14 -8192 to 9191
10 = 16sps, 15 -16384 to 16383
11 = 8sps, 16 -32768 to 32767
PGA1:0 Gain 00 = *1, 01 = *2, 10 = *4, 11 = *8
*/ #include <Wire.h> // AD0 1001 000 r/w AD1 1001 001 r/w ; r=1. w=0
#define AD0 B1001000 // ADS1100 地址0x48
#define options B10001100 // 0x8C-- 8SPS,16位精度,1倍放大 uint8_t reg = ;
int16_t result = ; void setup() {
Serial.begin();
Wire.begin();
Wire.beginTransmission(AD0);
Wire.write(options);
Wire.endTransmission();
} void loop() {
Wire.beginTransmission(AD0);
Wire.requestFrom(AD0, ); // 返回 3个 bytes
      while(Wire.available()) {
result = Wire.read();
result = result << ;
result += Wire.read();
reg = Wire.read();
Serial.print(result, DEC);
Serial.println("\t");
Serial.print((3300.00 * result)/ 0x7FFF, 2);//ADS1100接3.3V电源,如果接5V要将3300.00改为5000.00
Serial.println(" mV");
}
Wire.endTransmission();
delay();
}
上一篇:jinja模板语言


下一篇:escape、unescape、encodeURIComponent、decodeURLComponent