1. 重启后通过IP（Intelligent Provisioning）进入SSA（Smart Storage Administrator）界面收集
2. 选择Solid State Devices 后可以看见 SSD 硬盘的磨损值
3. 点击Diagnose
4. 点击 SmartSSD Wear Gayge Report ,出现了 Save SmartSSD Wear Gauge Report
5. 点击 SmartSSD Wear Gauge Report 保存
6. 保存成功后解压缩，就可以查看能到SSD日志
7. 可以查看到硬盘的磨损状态
8. 以下是关于SSD硬盘的状态描述
|
字段 |
说明 |
|
SSD Wear Status |
通过以下某条消息指示 SSD 的损耗状态： l OK l Not Supported l The SmartSSD Wear Gauge log is full. Wear Gauge parameters are not available l SSD has less than 5% usage remaining before wearout l SSD has less than 2% usage remaining before wearout l SSD has less than an estimated 56 days before it reaches the maximum usage limit for writes (wearout) and should be replaced as soon as possible l SSD has less than 5% of usage remaining before wearout. It has less than an estimated 56 days before it reaches the maximum usage limit and should be replaced as soon as possible l SSD has less than 2% of usage remaining before wearout. It has less than an estimated 56 days before it reaches the maximum usage limit and should be replaced as soon as possible l SSD has reached the maximum rated usage limit for writes (wearout) and should be replaced immediately |
|
Power Cycles |
指示 SSD 从电源关闭状态打开电源的次数 |
|
Power On Hours |
指示 SSD 已通电的小时数 |
|
Estimated Life Remaining Based On Workload To Date |
指示 SSD Utilization 达到 100% 之前可使用 SSD 的估计天数。当 SSD Utilization 仍为 0% 时不显示此字段。 |
|
Usage Remaining |
指示 SSD 尚未损耗的百分比。剩余用量等于 100 与 SSD Utilization 百分比之差。 |
|
SSD Utilization |
指示 SSD 已损耗的百分比 |